patch-2.3.35 linux/drivers/usb/README.scanner_hp_sane

• Lines: 70
• Date: Mon Dec 27 14:01:53 1999
• Orig file: v2.3.34/linux/drivers/usb/README.scanner_hp_sane
• Orig date: Wed Dec 31 16:00:00 1969

diff -u --recursive --new-file v2.3.34/linux/drivers/usb/README.scanner_hp_sane linux/drivers/usb/README.scanner_hp_sane
@@ -0,0 +1,69 @@
+Oct. 19, 1999
+
+CHANGES
+
+- Ammended for Linux-2.3.22+
+
+
+INTRODUCTION
+
+This document will hopefully provide enough info on how to get SANE
+working with a Hewlett Packard USB capable scanner using the USB
+interface.  The majority of HP Scanners support the Scanner Control
+Language (SCL) which is both published by HP and supported by SANE.
+The only HP Scanner that I'm aware of that does not support SCL is the
+4200C.  All other HP scanners with USB interfaces should work (4100C,
+5200C, 6200C, and 6300C).  Of course as HP releases new scanners this
+information may change.
+
+
+REQUIREMENTS
+
+In order to get this running you'll need USB support in your kernel in
+addition to USB Scanner support.  Please refer to README.scanner
+for issues pertaining to Linux USB and USB Scanner support.
+
+An installed version of SANE which is available from
+http://www.mostang.com/sane/.  Testing has been performed using
+version SANE-1.0.1.  For instructions on building and installing SANE,
+refer to the various README files within the SANE distribution.
+
+
+OK, I'VE INSTALLED SANE. SO WHAT DO I DO NOW?
+
+NOTE: $INSTALL_DIR is the location where SANE was installed.  It may
+be /usr/local, /usr, /opt or somewhere else.  If you don't know, ask
+your system administrator.
+
+1) Make sure that you have the libsane-hp.* libraries under the
+$INSTALL_DIR/lib/sane/ directory.  If you don't, then the HP backend
+was either not compiled or installed properly.
+
+2) Under the directory $INSTALL_DIR/etc/sane.d/ edit the following
+files: dll.conf, hp.conf.
+
+  dll.conf:  Make sure that the 'hp' entry is present and uncommented.
+
+  hp.conf: This should contain two lines:
+
+    /dev/usbscanner
+    option connect-device
+
+3) You should now be able to use SANE (xscanimage or scanimage).
+
+Don't forget to read any relevant man pages regarding the usage of
+SANE.  If you have other entries uncommented in dll.conf, you may have
+to specify the device to (x)scanimage.  Again, `man` is your friend.
+The xscanimage (1) man page has info on how to get 'The Gimp' to work
+with xscanimage.  Note that Gimp support must be compiled into SANE
+for it work.  If you are dealing with a RedHat system, this means that
+you'll also need to install the gimp-devel rpm package.
+
+NOTE: The issues regarding core dumping by (x)scanimage have (or seem
+to be thus far) been resolved with version 0.2+ of the USB scanner
+driver which should be available in linux-2.3.23.  If you notice
+otherwise, please contact me.
+
+David /\/elson
+dnelson@jump.net
+http://www.jump.net/~dnelson