patch-2.3.99-pre9 linux/arch/mips64/sgi-ip27/TODO

Next file: linux/arch/mips64/sgi-ip27/ip27-berr.c
Previous file: linux/arch/mips64/sgi-ip27/Makefile
Back to the patch index
Back to the overall index

diff -u --recursive --new-file v2.3.99-pre8/linux/arch/mips64/sgi-ip27/TODO linux/arch/mips64/sgi-ip27/TODO
@@ -4,8 +4,20 @@
 3. Need to figure out why address swaizzling is needed in inw/outw for 
 Qlogic scsi controllers.
 4. Need to integrate ip27-klconfig.c:find_lboard and 
+ip27-init.c:find_lbaord_real. DONE
 5. Is it okay to set calias space on all nodes as 0, instead of 8k as
 in irix?
 6. Investigate why things do not work without the setup_test() call
 being invoked on all nodes in ip27-memory.c.
+7. Too many CLIs in the locore handlers :
+For the low level handlers set up by set_except_vector(), 
+__tlb_refill_debug_tramp, __xtlb_refill_debug_tramp and cacheerror,
+investigate whether the code should do CLI, STI or KMODE. 
+8. Too many do_page_faults invoked - investigate.
+9. start_thread must turn off UX64 ... and define tlb_refill_debug.
+10. Need a bad pmd table, bad pte table. __bad_pmd_table/__bad_pagetable
+does not agree with pgd_bad/pmd_bad.
+11. All intrs (ip27_do_irq handlers) are targetted at cpu A on the node.
+This might need to change later. Only the timer intr is set up to be
+received on both Cpu A and B. (ip27_do_irq()/bridge_startup())
+13. Cache flushing (specially the SMP version) has to be investigated.

TCL-scripts by Sam Shen (who was at: