patch-2.4.10 linux/drivers/ide/sl82c105.c

• Lines: 46
• Date: Fri Sep 7 10:45:30 2001
• Orig file: v2.4.9/linux/drivers/ide/sl82c105.c
• Orig date: Tue Jul 3 17:08:19 2001

diff -u --recursive --new-file v2.4.9/linux/drivers/ide/sl82c105.c linux/drivers/ide/sl82c105.c
@@ -28,7 +28,6 @@
 
 extern char *ide_xfer_verbose (byte xfer_rate);
 
-#ifdef CONFIG_ARCH_NETWINDER
 /*
  * Convert a PIO mode and cycle time to the required on/off
  * times for the interface.  This has protection against run-away
@@ -272,37 +271,4 @@
 {
 	hwif->tuneproc = tune_sl82c105;
 }
-
-#else
-
-unsigned int pci_init_sl82c105(struct pci_dev *dev, const char *msg)
-{
-	return ide_special_settings(dev, msg);
-}
-
-void dma_init_sl82c105(ide_hwif_t *hwif, unsigned long dma_base)
-{
-	ide_setup_dma(hwif, dma_base, 8);
-}
-
-void __init ide_init_sl82c105(ide_hwif_t *hwif)
-{
-	struct pci_dev *dev = hwif->pci_dev;
-	unsigned short t16;
-	unsigned int t32;
-	pci_read_config_word(dev, PCI_COMMAND, &t16);
-	printk("SL82C105 command word: %x\n",t16);
-        t16 |= PCI_COMMAND_IO;
-        pci_write_config_word(dev, PCI_COMMAND, t16);
-	/* IDE timing */
-	pci_read_config_dword(dev, 0x44, &t32);
-	printk("IDE timing: %08x, resetting to PIO0 timing\n",t32);
-	pci_write_config_dword(dev, 0x44, 0x03e4);
-#ifndef CONFIG_MBX
-	pci_read_config_dword(dev, 0x40, &t32);
-	printk("IDE control/status register: %08x\n",t32);
-	pci_write_config_dword(dev, 0x40, 0x10ff08a1);
-#endif /* CONFIG_MBX */
-}
-#endif