patch-2.4.21 linux-2.4.21/drivers/usb/storage/unusual_devs.h

• Lines: 96
• Date: 2003-06-13 07:51:37.000000000 -0700
• Orig file: linux-2.4.20/drivers/usb/storage/unusual_devs.h
• Orig date: 2002-11-28 15:53:15.000000000 -0800

diff -urN linux-2.4.20/drivers/usb/storage/unusual_devs.h linux-2.4.21/drivers/usb/storage/unusual_devs.h
@@ -97,6 +97,22 @@
 		"DVD-CAM DZ-MV100A Camcorder",
 		US_SC_SCSI, US_PR_CB, NULL, US_FL_SINGLE_LUN),
 
+/* Reported by Khalid Aziz <khalid@gonehiking.org>
+ * This entry is needed because the device reports Sub=ff */
+UNUSUAL_DEV(  0x04b8, 0x0602, 0x0110, 0x0110,
+		"Epson",
+		"785EPX Storage",
+		US_SC_SCSI, US_PR_BULK, NULL, US_FL_SINGLE_LUN),
+
+/* Reported by Jan Willamowius <jan@willamowius.de>
+ * The device needs the flags only.
+ */
+UNUSUAL_DEV(  0x04c8, 0x0723, 0x0000, 0x9999,
+		"Konica",
+		"KD-200Z",
+		US_SC_SCSI, US_PR_BULK, NULL,
+		US_FL_START_STOP),
+
 UNUSUAL_DEV(  0x04cb, 0x0100, 0x0000, 0x2210,
 		"Fujifilm",
 		"FinePix 1400Zoom",
@@ -207,9 +223,9 @@
 		US_FL_FIX_INQUIRY | US_FL_START_STOP ),
 
 /* This entry is needed because the device reports Sub=ff */
-UNUSUAL_DEV(  0x054c, 0x0010, 0x0106, 0x0422, 
+UNUSUAL_DEV(  0x054c, 0x0010, 0x0106, 0x0440, 
 		"Sony",
-		"DSC-S30/S70/S75/505V/F505/F707", 
+		"DSC-S30/S70/S75/505V/F505/F707/F717", 
 		US_SC_SCSI, US_PR_CB, NULL,
 		US_FL_SINGLE_LUN | US_FL_START_STOP | US_FL_MODE_XLATE ),
 
@@ -239,6 +255,12 @@
 		US_SC_UFI, US_PR_CB, NULL,
 		US_FL_SINGLE_LUN | US_FL_START_STOP ),
 		
+UNUSUAL_DEV(  0x054c, 0x0069, 0x0000, 0x9999,
+		"Sony",
+		"Memorystick MSC-U03",
+		US_SC_UFI, US_PR_CB, NULL,
+		US_FL_SINGLE_LUN | US_FL_START_STOP ),
+
 /* Submitted by Nathan Babb <nathan@lexi.com> */
 UNUSUAL_DEV(  0x054c, 0x006d, 0x0000, 0x9999,
                 "Sony",
@@ -263,6 +285,15 @@
 		"USB Hard Disk",
 		US_SC_RBC, US_PR_CB, NULL, 0 ), 
 
+/* Enable USB storage access to the MMC/SD and CompactFlash cards inside the
+ * Pontis SP600 MP3 player (entry found on http://www.pontis.de/).
+ */
+UNUSUAL_DEV(  0x09bc, 0x0003, 0x0000, 0x9999,
+		"PONTIS",
+		"SP600",
+		US_SC_SCSI, US_PR_BULK, NULL,
+		US_FL_START_STOP ),
+
 #ifdef CONFIG_USB_STORAGE_ISD200
 UNUSUAL_DEV(  0x05ab, 0x0031, 0x0100, 0x0110,
                 "In-System",
@@ -487,6 +518,18 @@
 		US_FL_MODE_XLATE ),
 #endif
 
+/* Datafab KECF-USB / Sagatek DCS-CF / Simpletech Flashlink UCF-100
+ * Only revision 1.13 tested (same for all of the above devices,
+ * based on the Datafab DF-UG-07 chip).  Needed for US_FL_FIX_INQUIRY.
+ * Submitted by Marek Michalkiewicz <marekm@amelek.gda.pl>.
+ * See also http://martin.wilck.bei.t-online.de/#kecf .
+ */
+UNUSUAL_DEV(  0x07c4, 0xa400, 0x0000, 0xffff,
+		"Datafab",
+		"KECF-USB",
+		US_SC_SCSI, US_PR_BULK, NULL,
+		US_FL_FIX_INQUIRY ),
+
 /* Casio QV 2x00/3x00/4000/8000 digital still cameras are not conformant
  * to the USB storage specification in two ways:
  * - They tell us they are using transport protocol CBI. In reality they
@@ -506,6 +549,12 @@
  		US_SC_SCSI, US_PR_CB, NULL,
 		US_FL_MODE_XLATE ),
 
+UNUSUAL_DEV(  0x0a16, 0x8888, 0x0100, 0x0100,
+		"IBM",
+		"IBM USB Memory Key",
+		US_SC_SCSI, US_PR_BULK, NULL,
+		US_FL_FIX_INQUIRY ),
+		
 #ifdef CONFIG_USB_STORAGE_ISD200
 UNUSUAL_DEV(  0x0bf6, 0xa001, 0x0100, 0x0110,
                 "ATI",