patch-2.4.26 linux-2.4.26/drivers/net/sk98lin/h/skgehw.h

• Lines: 246
• Date: 2004-04-14 06:05:30.000000000 -0700
• Orig file: linux-2.4.25/drivers/net/sk98lin/h/skgehw.h
• Orig date: 2004-02-18 05:36:31.000000000 -0800

diff -urN linux-2.4.25/drivers/net/sk98lin/h/skgehw.h linux-2.4.26/drivers/net/sk98lin/h/skgehw.h
@@ -2,8 +2,6 @@
  *
  * Name:	skgehw.h
  * Project:	Gigabit Ethernet Adapters, Common Modules
- * Version:	$Revision: 1.56 $
- * Date:	$Date: 2003/09/23 09:01:00 $
  * Purpose:	Defines and Macros for the Gigabit Ethernet Adapter Product Family
  *
  ******************************************************************************/
@@ -22,236 +20,6 @@
  *
  ******************************************************************************/
 
-/******************************************************************************
- *
- * History:
- * $Log: skgehw.h,v $
- * Revision 1.56  2003/09/23 09:01:00  malthoff
- * Minor change: Define I2C device size constants as long.
- *
- * Revision 1.55  2003/09/16 14:03:34  rschmidt
- * Added define for YUKON-Lite Rev. A1,A2 Chip Revision
- * Moved defines for PHY power down modes to skgeinit.h
- * Editorial changes
- *
- * Revision 1.54  2003/09/16 07:37:58  mschmid
- * Added defines for Marvell PHY low power modes
- *
- * Revision 1.53  2003/07/04 12:39:01  rschmidt
- * Added SK_FAR to pointers in XM_IN32() and GM_IN32() macros (for PXE)
- * Editorial changes
- *
- * Revision 1.52  2003/05/13 17:16:36  mkarl
- * Added SK_FAR for PXE.
- * Editorial changes.
- *
- * Revision 1.51  2003/04/08 16:31:50  rschmidt
- * Added defines for new Chip IDs (YUKON-Lite, YUKON-LP)
- * Editorial changes
- *
- * Revision 1.50  2003/03/31 07:29:45  mkarl
- * Corrected Copyright.
- * Editorial changes.
- *
- * Revision 1.49  2003/01/28 09:43:49  rschmidt
- * Added defines for PCI-Spec. 2.3 IRQ
- * Added defines for CLK_RUN (YUKON-Lite)
- * Editorial changes
- *
- * Revision 1.48  2002/12/05 10:25:11  rschmidt
- * Added defines for Half Duplex Burst Mode On/Off
- * Added defines for Rx GMAC FIFO Flush feature
- * Editorial changes
- *
- * Revision 1.47  2002/11/12 17:01:31  rschmidt
- * Added defines for WOL_CTL_DEFAULT
- * Editorial changes
- *
- * Revision 1.46  2002/10/14 14:47:57  rschmidt
- * Corrected bit mask for HW self test results
- * Added defines for WOL Registers
- * Editorial changes
- *
- * Revision 1.45  2002/10/11 09:25:22  mkarl
- * Added bit mask for HW self test results.
- *
- * Revision 1.44  2002/08/16 14:44:36  rschmidt
- * Added define GPC_HWCFG_GMII_FIB for YUKON Fiber
- *
- * Revision 1.43  2002/08/12 13:31:50  rschmidt
- * Corrected macros for GMAC Address Registers: GM_INADDR(),
- * GM_OUTADDR(), GM_INHASH, GM_OUTHASH.
- * Editorial changes
- *
- * Revision 1.42  2002/08/08 15:37:56  rschmidt
- * Added defines for Power Management Capabilities
- * Editorial changes
- *
- * Revision 1.41  2002/07/23 16:02:25  rschmidt
- * Added macro WOL_REG() to access WOL reg. (HW-Bug in YUKON 1st rev.)
- *
- * Revision 1.40  2002/07/15 15:41:37  rschmidt
- * Added new defines for Power Management Cap. & Control
- * Editorial changes
- *
- * Revision 1.39  2002/06/10 09:37:07  rschmidt
- * Added macros for the ADDR-Module
- *
- * Revision 1.38  2002/06/05 08:15:19  rschmidt
- * Added defines for WOL Registers
- * Editorial changes
- *
- * Revision 1.37  2002/04/25 11:39:23  rschmidt
- * Added new defines for PCI Our Register 1
- * Added new registers and defines for YUKON (Rx FIFO, Tx FIFO,
- * Time Stamp Timer, GMAC Control, GPHY Control,Link Control,
- * GMAC IRQ Source and Mask, Wake-up Frame Pattern Match);
- * Added new defines for Control/Status (VAUX available)
- * Added Chip ID for YUKON
- * Added define for descriptors with UDP ext. for YUKON
- * Added macros to access the GMAC
- * Added new Phy Type for Marvell 88E1011S (GPHY)
- * Editorial changes
- *
- * Revision 1.36  2000/11/09 12:32:49  rassmann
- * Renamed variables.
- *
- * Revision 1.35  2000/05/19 10:17:13  cgoos
- * Added inactivity check in PHY_READ (in DEBUG mode only).
- *
- * Revision 1.34  1999/11/22 13:53:40  cgoos
- * Changed license header to GPL.
- *
- * Revision 1.33  1999/08/27 11:17:10  malthoff
- * It's more savely to put brackets around macro parameters.
- * Brackets added for PHY_READ and PHY_WRITE.
- *
- * Revision 1.32  1999/05/19 07:31:01  cgoos
- * Changes for 1000Base-T.
- * Added HWAC_LINK_LED macro.
- *
- * Revision 1.31  1999/03/12 13:27:40  malthoff
- * Remove __STDC__.
- *
- * Revision 1.30  1999/02/09 09:28:20  malthoff
- * Add PCI_ERRBITS.
- *
- * Revision 1.29  1999/01/26 08:55:48  malthoff
- * Bugfix: The 16 bit field relations inside the descriptor are
- * 	endianess dependend if the descriptor reversal feature
- * 	(PCI_REV_DESC bit in PCI_OUR_REG_2) is enabled.
- * 	Drivers which use this feature has to set the define
- * 	SK_USE_REV_DESC.
- *
- * Revision 1.28  1998/12/10 11:10:22  malthoff
- * bug fix: IS_IRQ_STAT and IS_IRQ_MST_ERR has been twisted.
- *
- * Revision 1.27  1998/11/13 14:19:21  malthoff
- * Bug Fix: The bit definition of B3_PA_CTRL has completely
- * changed from HW Spec v1.3 to v1.5.
- *
- * Revision 1.26  1998/11/04 08:31:48  cgoos
- * Fixed byte ordering in XM_OUTADDR/XM_OUTHASH macros.
- *
- * Revision 1.25  1998/11/04 07:16:25  cgoos
- * Changed byte ordering in XM_INADDR/XM_INHASH again.
- *
- * Revision 1.24  1998/11/02 11:08:43  malthoff
- * RxCtrl and TxCtrl must be volatile.
- *
- * Revision 1.23  1998/10/28 13:50:45  malthoff
- * Fix: Endian support missing in XM_IN/OUT-ADDR/HASH macros.
- *
- * Revision 1.22  1998/10/26 08:01:36  malthoff
- * RX_MFF_CTRL1 is split up into RX_MFF_CTRL1,
- * RX_MFF_STAT_TO, and RX_MFF_TIST_TO.
- * TX_MFF_CTRL1 is split up TX_MFF_CTRL1 and TX_MFF_WAF.
- *
- * Revision 1.21  1998/10/20 07:43:10  malthoff
- * Fix: XM_IN/OUT/ADDR/HASH macros:
- * The pointer must be casted.
- *
- * Revision 1.20  1998/10/19 15:53:59  malthoff
- * Remove ML proto definitions.
- *
- * Revision 1.19  1998/10/16 14:40:17  gklug
- * fix: typo B0_XM_IMSK regs
- *
- * Revision 1.18  1998/10/16 09:46:54  malthoff
- * Remove temp defines for ML diag prototype.
- * Fix register definition for B0_XM1_PHY_DATA, B0_XM1_PHY_DATA
- * B0_XM2_PHY_DATA, B0_XM2_PHY_ADDR, B0_XA1_CSR, B0_XS1_CSR,
- * B0_XS2_CSR, and B0_XA2_CSR.
- *
- * Revision 1.17  1998/10/14 06:03:14  cgoos
- * Changed shifted constant to ULONG.
- *
- * Revision 1.16  1998/10/09 07:05:41  malthoff
- * Rename ALL_PA_ENA_TO to PA_ENA_TO_ALL.
- *
- * Revision 1.15  1998/10/05 07:54:23  malthoff
- * Split up RB_CTRL and it's bit definition into
- * RB_CTRL, RB_TST1, and RB_TST2.
- * Rename RB_RX_HTPP to RB_RX_LTPP.
- * Add ALL_PA_ENA_TO. Modify F_WATER_MARK
- * according to HW Spec. v1.5.
- * Add MFF_TX_CTRL_DEF.
- *
- * Revision 1.14  1998/09/28 13:31:16  malthoff
- * bug fix: B2_MAC_3 is 0x110 not 0x114
- *
- * Revision 1.13  1998/09/24 14:42:56  malthoff
- * Split the RX_MFF_TST into RX_MFF_CTRL2,
- * RX_MFF_TST1, and RX_MFF_TST2.
- * Rename RX_MFF_CTRL to RX_MFF_CTRL1.
- * Add BMU bit CSR_SV_IDLE.
- * Add macros PHY_READ() and PHY_WRITE().
- * Rename macro SK_ADDR() to SK_HW_ADDR()
- * because of conflicts with the Address Module.
- *
- * Revision 1.12  1998/09/16 07:25:33  malthoff
- * Change the parameter order in the XM_INxx and XM_OUTxx macros,
- * to have the IoC as first parameter.
- *
- * Revision 1.11  1998/09/03 09:58:41  malthoff
- * Rework the XM_xxx macros. Use {} instead of () to
- * be compatible with SK_xxx macros which are defined
- * with {}.
- *
- * Revision 1.10  1998/09/02 11:16:39  malthoff
- * Temporary modify B2_I2C_SW to make tests with
- * the GE/ML prototype.
- *
- * Revision 1.9  1998/08/19 09:11:49  gklug
- * fix: struct are removed from c-source (see CCC)
- * add: typedefs for all structs
- *
- * Revision 1.8  1998/08/18 08:27:27  malthoff
- * Add some temporary workarounds to test GE
- * sources with the ML.
- *
- * Revision 1.7  1998/07/03 14:42:26  malthoff
- * bug fix: Correct macro XMA().
- * Add temporary workaround to access the PCI config space over I/O
- *
- * Revision 1.6  1998/06/23 11:30:36  malthoff
- * Remove ';' with ',' in macors.
- *
- * Revision 1.5  1998/06/22 14:20:57  malthoff
- * Add macro SK_ADDR(Base,Addr).
- *
- * Revision 1.4  1998/06/19 13:35:43  malthoff
- * change 'pGec' with 'pAC'
- *
- * Revision 1.3  1998/06/17 14:58:16  cvs
- * Lost keywords reinserted.
- *
- * Revision 1.1  1998/06/17 14:16:36  cvs
- * created
- *
- *
- ******************************************************************************/
-
 #ifndef __INC_SKGEHW_H
 #define __INC_SKGEHW_H